Specifications - Wilson Electronics 4G LTE 700 Installation Manual

Hide thumbs

Table of Contents

4G LTE 700 Specifications

Model Number

Antenna connectors

Antenna impedance

Dimensions

Weight

Frequency

Passband Gain (nominal)

20 dB Bandwidth (nominal)

Power Output

Power output for single cell phone (uplink) or single received channel

Power output for multiple channels

The maximum power is reduced

by the number of channels:

Noise Figure (typical downlink/uplink)

Isolation

Power Requirements

Notes:

1 . Nominal gain is the maximum gain at any frequency in the passband .

2 . Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB lower than the passband

amplification . One of the frequencies is lower than the passband and the other is higher .

3 . The Manufacturer's rated output power of this equipment is for single carrier operation . For situations when multiple carrier signals are present, the rating

would have to be reduced by 3 .5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users . This power

reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device .

4 . The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled .

3301 East Deseret Drive, St . George, UT 84790

For additional Technical Support visit www .WilsonElectronics .com

Phone: 866-294-1660

www .twitter .com/WilsonCellular

Uplink/Downlink

Uplink (776 - 787 MHz)

Downlink (746 - 757 MHz)

Number of channels

or email at: tech@wilsonelectronics .com