Making Connection Mode Settings; Making Nat Settings - Panasonic KX-VC1600 User Manual

Contacts and Settings
Making Connection Mode
Settings
1.
Select "Connection mode" and press [ENTER].
•
The connection mode setting screen is
displayed.
2.
Press [ENTER], use [
connection mode, and then press [ENTER] again.
"IP Mode": Communication is established over the
Internet or an intranet.
"NAT Traversal Mode": Communication is
established using KX-VC Series NAT Traversal
Service.
"IP / NAT Traversal Mode": Performs
communication using the 2 modes of IP Mode and
NAT Traversal Mode.
Note
•
Communication cannot be established with
a party whose connection mode setting
differs from yours.
•
"NAT Traversal Mode" can be used only
after activating KX-VC Series NAT
Traversal Service with an activation key.
For details about KX-VC Series NAT
Traversal Service, refer to the following web
site:
http://panasonic.net/psn/products/hdvc/
nat_traversal/index.html
3.
Press [G].
•
A dialogue box to confirm the saving of settings
and system restart after saving is displayed.
4.
Use [ ][ ] to select "Yes" and press [ENTER].
•
The system will automatically restart to reflect
changes to system settings.
Note
•
When changing the connection mode, the time
required for a restart may depend on network
conditions.

Making NAT Settings

Note
•
To change the static NAT settings, it is
necessary to configure system settings,
including the port number settings. For details,
contact your dealer.
122 User Manual
][ ] to select the desired
•
When using IP mode (Page 122), "NAT" is not
displayed in step 2.
•
When using NAT traversal mode (Page 122),
"Static NAT", "WAN IP Address", and "Local
address judgement" are not displayed in step
2.
•
This setting is available only when "IP Address
(LAN 1)" (setting) is set to "Manual" in
"Network Settings" (Page 102).
1.
Select "NAT Settings" and press [ENTER].
•
The NAT settings screen is displayed.
2.
Use [ ][ ] to select the following items for input:
•
The following items are displayed over 2 pages.
To view all the items, press [R] to move to the
next page, and press [B] to move to the
previous page.
•
If the settings have been changed, press [G]
before changing to a different screen to save
the settings.
"NAT": Press [ENTER] and use [
"Dynamic" (default) or "Static".
"Static NAT": Use [
"OFF" (default).
Note
•
To select "ON", "H.460" must be set to
"OFF" on the H.323 settings screen
(Page 125).
•
When "ON" is selected, the IP address of
the WAN side will be displayed for the unit
information on the Home screen (Page 38).
"WAN IP Address": Enter the WAN IP address of
the router.
Note
•
IPv6 addresses cannot be used for setting.
•
If the IP address contains 1 or 2 digit
numbers, enter these numbers as they are.
Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
•
If "Obtain automatically" is displayed, the
WAN IP address cannot be set. For details,
contact your dealer.
"Local address judgement": Press [ENTER] and
use [ ][ ] to select "OFF" (default) or "Auto".
–
"OFF" (default): Static NAT is applied to all
addresses.
–
"Auto": Static NAT is not applied to private
addresses.
][ ] to select
][ ] to select "ON" or
Document Version 2015-08