Ordering Replacement Parts - GREAT PLANES Gee Bee Instruction Manual

IMPORTANT INFORMATION ABOUT WORKING WITH FIBERGLASS
If you have never worked with fiberglass there are a few
basic things you should be aware of:
1. When you are cutting into fiberglass, be sure you are
cutting the correct place. Unlike wood, you are not able to
go back and easily fix a mistake.
2. Whenever you are gluing a part to the inside of fiberglass
it is important to roughen the inside surface of the fiberglass
with 220-grit sandpaper. Then wipe the area with alcohol.
The molding process leaves a waxy residue that can prevent
a good bond between the glue and the parts being glued.
To order replacement parts for the Great Planes Gee Bee ARF, use the order numbers in the Replacement Parts List
that follows. Replacement parts are available only as listed. Not all parts are available separately (an aileron cannot be
purchased separately, but is only available with the wing kit). Replacement parts are not available from Product Support,
but can be purchased from hobby shops or mail order/Internet order firms. Hardware items (screws, nuts, bolts) are also
available from these outlets. If you need assistance locating a dealer to purchase parts, visit www.greatplanes.com and
click on "Where to Buy." If this kit is missing parts, contact Product Support.
Order Number
GPMA2390 ...........Wing Kit
GPMA2391 ...........Fuselage Kit
GPMA2392 ...........Stabilizer Set
GPMA2393 ...........Rudder
GPMA2394 ...........Landing Gear Set
GPMA2395 ...........Wheel Pants
GPMA2396 ...........Canopy
GPMA2397 ...........Cowl
GPMA2398 ...........Decal Set
Inch Scale
0" 1"
0 10 20 30
Metric Scale

ORDERING REPLACEMENT PARTS

Replacement Parts List
Description
Missing pieces ................................................Contact Product Support
Instruction manual...........................................Contact Product Support
Full-size plans .................................................Not available
Kit parts listed below.......................................Hobby Supplier
To convert inches to millimeters, multiply inches by 25.4
2" 3"
40 50 60 70
3. If you do not have a high-speed motor tool such as a
Dremel ® tool, you should consider purchasing one or
borrowing one from a fellow modeler. This combined with a
fiberglass cut-off wheel is going to be extremely helpful in
the assembly process.
WARNING: The cowl, wheel pants and fuselage included in
this kit are made of fiberglass, the fibers of which may
cause eye, skin and respiratory tract irritation. Never blow
into a part to remove fiberglass dust, as the dust will blow
back into your eyes. Always wear safety goggles, a particle
mask and rubber gloves when grinding, drilling and sanding
fiberglass parts. Vacuum the parts and the work area
thoroughly after working with fiberglass parts.
4"
80 90 100 110 120 130 140 150 160 170 180
5
How to Purchase
5" 6" 7"