Panasonic KX-NTV150 User Manual page 33

2.
IP Video Doorphone talking automatically begins by making a call from the Internal line to the IP Video
Doorphone. In this case, video monitoring starts automatically too. Light source LED turns on
(depending on embedded web menu settings). Confirmation tone is sent to both the doorphone and
internal line.
3.
Indication of calling status (Ringing confirmation tone and turning the blue LED on), can be configured
with the embedded web menu. Default values are "No Confirmation Tone when talking starts", "LED
is steady Green", "When ending the talking, user does NOT hear the Reorder tone". Please note that
the light source LED does not follow this setting. About the setting, please refer to page 64.
4.
Users can not make a call to the IP Video Doorphone that is OUS (Out Of Service). In this case, an
internal line Reorder Tone is heard depending on the PBX used.
5.
If the IP Video Doorphone is called by another extension during Doorphone talking, the Doorphone will
be busy (SIP multi session is not supported).
4.
IP Video Doorphone talking with optional door opener control
1.
The callee can operate the door opener (Digital output) after answering IP Video Doorphone call or IP
Video Doorphone talking.
Relay is turned On by an external IO Output. Relay control I/O logic and make time can be modified
with the Embedded Web menu.
2.
Camera control (ePTZ) is available after answering by callee and during talking. ePTZ can be controlled
by exclusive software or Dial Key detection. Please see the figure below which shows operations and
the Dial Key number.
*Door locking depends on the door opener (Digital output) specifications.
IP Video Doorphone cannot lock the door.
Once the camera receives Dial Key 5 after opening the door, conversations will end after 8 seconds.
Once Dial Key 5 is received, the camera will not receive Dial Key 5 until the next conversation.
3.
IP Video Doorphone talking ends in following cases.
If talking ended, video monitor ends too. Status LED turns on green, light source LED turns off
depending on the embedded Web menu setting.
1.
Callee finishes Doorphone talking.
Talking ends after ringing re-order tone for 3 seconds after the callee ends talking.
* This behavior depends on the embedded web menu settings.
2.
Limit of conversation time has elapsed since starting the doorphone call.
Talking ends after ringing re-order tone for 3 seconds.
Dial Key 2
Dial Key 4
Dial Key 8
Dial Key 7
Dial Key 5: Digital Output
Dial Key*: Ending video monitor,
Dial Key 6
Dial Key 9
start to talk
1 Operations
User's Manual 33