Panasonic KX-NTV150 User Manual page 29

The same applies for after pressing Dial Key
Key confirmation tone and goes back to idle status. The video will be stopped and the status LED turns
on green.
15.
Outgoing call triggered by an event
•
The following events can trigger an outgoing call. Users can turn on/off each event with the
embedded web menu.
"Video motion detection"
"Periodically"
"Digital input"
"System boot"
"Recording notify"
"Voice detection"
"Camera tampering detection"
"Manual triggers"
•
SIP outgoing action is ignored during Communication IP Camera call or Communication IP Camera
talking.
•
Other operations are the same as triggered by pressing call button.
*1
Call ring duration is variable.
Call ring duration: 10 seconds-150 seconds
Default: 30 seconds
3.
Make a call from Internal line
1.
User can establish a call with Communication IP Camera by dialing internal line number assigned to
Communication IP Camera.
* Internal line number for Communication IP Camera is changeable by embedded web menu. Please
refer to page 61.
2.
Communication IP Camera talking automatically begins by making a call from Internal line to
Communication IP Camera. In this case, video monitor starts automatically too. Confirmation tones are
sent to both IP Camera and internal line. Status LED will turn Blue on.
3.
Indication of calling status (Ringing confirmation tone and turning Blue LED on) can be configurable
by embedded web menu. Default values are "No Confirmation Tone when talking starts", "LED is steady
Green", "When ending the talking, user does NOT hear the Reorder tone". About the setting, please
refer to page 64.
4.
Users cannot make a call to the Communication IP Camera that is OUS (Out Of Service). In this case,
an internal line Reorder Tone is heard depending on the PBX used.
5.
If the Communication IP Camera is called by another extension while the Communication IP Camera
is talking, the Communication IP Camera is busy (SIP multi session is not supported).
6.
If the user presses a call button again while the Communication IP Camera is calling, the call ends.
The video will be stopped and the status LED turn on green.
4.
Communication IP Camera talking with optional door opener control
1.
The callee can operate a door opener (Digital output) after answering the Communication IP Camera
call or Communication talking. The relay is turned on by an external IO Output. The relay control I/O
logic and make time can be modified with the Embedded Web menu. Please refer to Digital output on
page 93.
. If a user presses the call button again, it sounds the
*1
1 Operations
User's Manual 29