American Megatrends StorTrends 3600i Setup Manual page 99

S tep Action
2 On the physical hard drive press the red handle release button, and use the handle to pull the drive about
an inch from backplane, but resting in the slot.
3 Wait a full 3 (three) minutes before removing the failed drive from the slot.
S tep Action
4 After completing the 3 minute wait period, remove the failed drive, insert the replacement drive and latch
the handle.
5 Browse to the M anageTrends System Hardware Health Information display. Press the F5 key on the
keyboard to refresh the display; then, verify the replacement disk is properly displayed on the system.
StorTrends® 3600i/3610i Dual Controller IP-SAN Storage Appliance Setup Guide Page 99