American Megatrends StorTrends 3600i Setup Manual page 10

Requirements
The rack rails supplied with your system are designed to be used with four post rack
enclosures. The rack rails mount between the posts and are designed to be quickly
installed.
In order for you to use the supplied rack rails, your rack enclosure must conform to the
following:
•
Must be a 19 inch rack mount cabinet
•
Must be at least 27 inches deep
•
Must have square holes on the posts (sometimes referred to as, "rapid rack holes.")
•
Must have a side clearance of 0.75 inches in between the posts, from square
mounting hole to square mounting hole.
Meaning if you take a (0.75 inch) wide by (5.75 inch) tall by (the amount of space
between the posts) length of wood and place it between the posts, it should not be
exposed in a way that would restrict you from sliding your system into your rack
enclosure.
Follow the steps in the order given to complete the installation process in a minimal
amount of time. Read this section in its entirety before you begin the installation
procedure outlined in this section.
StorTrends® 3600i/3610i Dual Controller IP-SAN Storage Appliance Setup Guide
NOTE:
Page 10