American Megatrends StorTrends 3600i Setup Manual page 14

Installing the Outer Rack Rails into the Rack
Locate the front of the outer rack rail and attach it to the rack. To do this, simply push the
outer rack rail into the back of the rack post. The plastic securing pins will retract so that
you can latch the outer rack rail into place. Once the outer rack rail is latched into place
the securing plastic pins will pop back out.
Quick Rail Instalation
Sliding the rear of the outer rack rail until it comes into contact with the back post. Make
sure that the outer rack rail is level and secure it to the port in the same manner as you did
with the front of the outer rack rail.
Secure the outer rack rail to the rack posts with four screws. Two for the front post and
two for the rear post.
Repeat this process with the remaining outer rack rail.
Line up the inner rack rails of the chassis with the outer rack rails on the rack.
Slide the chassis into place until it comes to a stop.
Verify that both sides of the chassis come to a stop at the same location.
Lift the locking tab on the inner rack rails so that you can slide the chassis all the way
into the rack.
StorTrends® 3600i/3610i Dual Controller IP-SAN Storage Appliance Setup Guide Page 14