Special Tools - Toro 30821 Service Manual

Special Tools

Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The meter can test electrical components and circuits
for current, resistance, or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt-
Ohm- Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Battery Terminal Protector
Battery Terminal Protector (Toro Part No. 107- 0392) is
an aerosol spray that should be used on battery termi-
nals to reduce corrosion problems. Apply terminal pro-
tector after battery cable has been secured to battery
terminal.
Dielectric Gel
Toro Part Number: 107- 0342
Dielectric gel should be used to prevent corrosion of un-
sealed connection terminals. To ensure complete coat-
ing of terminals, liberally apply gel to both component
and wire harness connector, plug connector to compo-
nent, unplug connector, reapply gel to both surfaces and
reconnect harness connector to component. Connec-
tors should be thoroughly packed with gel for effective
results.
Do not use dielectric gel on sealed connection terminals
as the gel can unseat connector seals during assembly.
Groundsmaster 3500- D Page 5 - 3
Figure 1
Figure 2
Figure 3
Electrical System (Rev. G)