Rear Wheel Motor
15
250 to 350 ft- lb
(339 to 474 N- m)
RIGHT
FRONT
1.
Lug nut
2.
Drive stud
3.
Tire and rim assembly
4.
Wheel hub
5.
Hydraulic hose
Removal (Fig. 82)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 - Safety.
2. Jack up rear of equipment enough to allow the re-
moval of the rear wheel.
3. Remove rear tire and rim assembly from machine.
Hydraulic System (Rev. G)
1
45 to 65 ft- lb
(61 to 88 N- m)
3
4
14
6.
Hydraulic hose
7.
O- ring
o
8.
45
hydraulic fitting
9.
Lock nut
10. Socket head screw
2
8
13
9
11
Figure 82
4. Remove rear wheel motor with wheel hub attached
from the rear fork using Figure 82 as guide.
5. Secure wheel hub in a vise. Loosen but do not re-
move lock nut that secures wheel hub to wheel motor.
IMPORTANT: DO NOT hit wheel hub, wheel hub
puller or wheel motor with a hammer during wheel
hub removal or installation. Hammering may cause
damage to the wheel motor.
6. Using hub puller (see Special Tools), loosen wheel
hub from wheel motor.
7. Remove wheel hub and motor from vise. Remove
lock nut and hub from motor shaft. Locate and retrieve
woodruff key.
Page 4 - 72
5
7
6
7
8
13
11. Hydraulic motor
12. Rear fork
13. O- ring
14. Woodruff key
15. Lock nut
Groundsmaster 3500- D
12
10