Sidewinder Carrier - Toro 30821 Service Manual

Sidewinder Carrier

RIGHT
FRONT
1. Lower frame
2. Sidewinder carrier assembly
3. Slide bracket
4. Plastic slide
5. Flange head screw
Disassembly
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disassemble sidewinder carrier as needed using
Figures 17, 20, and 21 as guides.
Wheels, Brakes, and Chassis
1 13
12
67 to 83 ft- -lb
(91 to 113 Nm)
Figure 21
6. Flange nut
7. Cap screw
8. Thrust washer
9. Slide support bar
Page 6 - - 22
2
10
10
9
8
7
10. Bearing cap
11. Lock nut
12. Liftarm (RH shown)
13. Liftarm pivot shaft
Assembly
1. Assemble sidewinder carrier using Figures 21 as
guide.
A. Do not lubricate sidewinder cross tube as bearing
caps and slides are self lubricating.
B. Tighten the bearing cap screws from 67 to 83 ft--lb
(91 to 113 Nm).
2. Use Figures 17 and 20 to complete the assembly
process (see Front Lift Arms and Rear Lift Arm).
6
11
8
4
4
3
5
Groundsmaster 3500--D