Toro 30821 Service Manual page 39

10.Connect wire harness and electrical wires to the fol-
lowing:
A. Engine grounds to the battery and wire harness
(Fig. 21).
B. Glow plug bus (Fig. 22) and fuel stop solenoid.
C. High temperature warning switch (Fig. 23).
D. High temperature shutdown switch, alternator,
and low oil pressure switch (Fig. 24).
11. Secure wire harness to engine with cable ties at loca-
tions noted during engine removal.
12.Connect coolant hoses to the water pump and en-
gine block. Make sure drain cock valve is closed. Fill ra-
diator with coolant (see Check Cooling System).
13.Install muffler to the exhaust manifold and muffler
bracket (see Muffler Installation).
Groundsmaster 3500- D
14.Connect throttle cable to the support and swivel on
the speed control lever (Fig. 21).
15.Connect both battery cables at the battery (see Bat-
tery Service in Chapter 5 - Electrical system).
16.Install air cleaner to the engine. Connect air hose to
air cleaner and radiator.
17.Adjust throttle cable (see Adjust Throttle Cable).
18.Bleed fuel system (see Bleed Fuel System).
19.Install engine hood to the machine. Close and latch
hood.
20.Check hydraulic oil level. Adjust as needed.
21.Adjust traction drive for neutral (see Adjust Traction
Drive for Neutral in Chapter 4- Hydraulic System).
Page 3 - 19 Kubota Diesel Engine (Rev. G)