Service And Repairs; Standard Seat - Toro 30821 Service Manual

Service and Repairs

Standard Seat

1
12
11
1. Seat (incl. 4 thru 7, 14, & 15)
2. Cap screw
3. Spring lock washer
4. Edging clip
5. Edging
6. Seat cushion
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove four hex flange head screws securing the
seat support straps to the frame. Note location of
spacers under front of seat support straps.
3. Disconnect electrical connector from the seat switch.
Separate seat from the frame.
4. Remove seat parts as necessary to make repairs us-
ing Figure 9 as a guide.
Wheels, Brakes, and Chassis
8
3
2
13
18
10
17
7. Seat shell
8. Seat belt
9. Seat adjuster with latch
10. Flange hex nut
11. Cap screw
12. Lock washer
15
14
9
16
10
18
Figure 9
Installation
1. Install any new seat parts using Figure 9 as a guide.
2. Position seat, spacers and support straps to the fuel
tank and frame.
3. Connect electrical connector to the seat switch.
4. Secure seat support straps to the frame with four hex
flange head screws.
Page 6 - - 8
4
5
6
7
8
3
2
13. Seat adjuster
14. Cap screw
15. Seat switch
16. Hex flange head screw
17. Seat support strap
18. Hex flange head screw
Groundsmaster 3500--D