Toro 30821 Service Manual page 36

Engine
41
RIGHT
FRONT
1. Kubota engine
2. Engine mount
3. Engine mount
4. Flange nut
5. Cap screw
6. Hex flange head screw
7. External lock washer
8. Lock nut
9. Hardened washer
10. Machine screw
11. Hardened washer
12. Cap screw
13. Engine mounting bracket (front)
14. Engine mounting bracket (LH)
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open and remove engine hood from the machine
(see Hood Removal in Chapter 6 - Wheels, Brakes, and
Chassis). Slide seat all the way forward.
3. Disconnect air hose from the air cleaner and radiator.
Remove air cleaner from the engine.
Kubota Diesel Engine (Rev. G)
39
37
21
15
36
16
11
2
5
9
32
34
6
35
13
17
18
3
4
11
12
11
10
15. Engine mounting bracket (RH)
16. Cap screw
17. Pulley
18. Bolt
19. Flange nut
20. Washer
21. Exhaust gasket
22. Throttle swivel
23. Lock nut
24. Slotted hex head screw
25. Throttle cable clamp
26. Cap screw
27. R- clamp
28. Lock nut
1
29
33
30 16
31
14
20
6
2
9
20
8
27
Figure 20
4. Disconnect both battery cables at the battery (see
Battery Service in Chapter 5 - Electrical System).
5. Remove muffler from the exhaust manifold and muf-
fler bracket (see Muffler Removal).
6. Drain radiator from the drain cock valve into a suit-
able container (see Radiator Removal). Disconnect
coolant hoses from the water pump and engine block.
7. Remove coolant expansion tank and bracket from
the top fan shroud. Remove top fan shroud from the ra-
diator (see Radiator Removal).
Page 3 - 16
37
38
23
40
22
24
28
25
26
19
5
11
16
7
4
29. Lock washer
30. Flat washer
31. Flange head screw
32. Flat washer
33. R- clamp
34. Lock washer
35. Hex nut
36. Wire harness
37. Hose clamp
38. Radiator hose (upper)
39. Radiator hose (lower)
40. Throttle support bracket
41. Pump mount plate
Groundsmaster 3500- D