Front Roller Service - Toro 30821 Service Manual

Front Roller Service

Disassembly (Fig. 25)
1. Remove roller mounting bolt.
2. Remove roller assembly from carrier frame.
3. To remove bearings and spacer:
A. Insert punch through end of roller and drive oppo-
site bearing out by alternating taps to opposite side of
inner bearing race. There should be a lip of inner race
exposed for this process.
B. Remove spacer. Remove second bearing from
roller using a press.
4. Inspect roller housing, bearings, and bearing spacer
for damage or wear. Replace components as needed.
Assembly (Fig. 25)
1. Install bearings and bearing spacer into roller:
A. Press first bearing into housing. Press on outer
race only or equally on inner and outer races.
B. Insert bearing spacer.
C. Press second bearing into roller housing press-
ing equally on inner and outer races until the inner
race comes in contact with the spacer.
2. Install roller assembly into deck frame.
Cutting Units (Rev. D)
2
3
4
1. Mounting bolt
2. Bearing
NOTE: Securing roller assembly with a gap larger than
.060 inch (1.52 mm) creates a side load on bearings and
can lead to premature bearing failure.
3. Verify that there is no more than a .060 inch (1.52
mm) gap between roller assembly and the roller mount
brackets of the deck frame. If this gap is larger than .060
inch (1.5 mm), shim excess clearance with 5/8" wash-
ers.
4. Insert mounting bolt and tighten to 80 ft--lb (108
N--m).
Rev. E
Page 7 - - 16
80 ft- -lb
(108 N- -m)
2
Figure 25
3. Spacer
4. Front roller
Groundsmaster 3500--D
1