Toro 30821 Service Manual page 155

Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove steering control valve from the steering col-
umn using Figures 114, 115, and 116 as guides.
Installation
1. Install steering control valve to the steering column
using Figures 114, 115, and 116 as guides. When instal-
ling steering control valve, note position of end cover
protrusion as shown (Fig. 116).
2. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Check Hydraulic System Fluid).
Groundsmaster 3500- D
2
6
8
1. Tilt bracket
2. Steering valve bracket
3. Jam nut
4. Flat washer
6
4
1. Cap screw
2. Flange nuts
3. Steering valve bracket
4. Steering arm
Page 4 - 115
1
3
4
5
7
Figure 115
5. Friction disc
6. Steering tilt lever
7. Steering arm
8. Friction disc
5
3
7
2
Figure 116
5. Steering control valve
6. Steering tilt lever
7. End cover protrusion
Hydraulic System (Rev. G)
1