Storing A Program - Sharp AR-FX7 Operation Manual

If you cannot edit or delete a group key
Note
If you attempt to edit or delete a group key in the following situations, a warning message will appear and
editing/deletion will not be possible.
• The rapid key you wish to change or delete is currently being used for transmission or is used in a currently
stored transmission job (including a timer transmission). ("CANCELING A FAX TRANSMISSION" (p.24))
• The group key is included in the end receiving machines for an F-code relay broadcast operation. ("Editing or
deleting a memory box" (p.105))
• The group key is included in a program. ("EDITING AND DELETING PROGRAMS" (p.74))
If the key is being used for a current transmission or currently stored transmission, cancel the transmission or
wait until it is completed and then edit or delete the key. If the key is included in a program or in the end receiving
machines for an F-code relay broadcast operation, delete the key from the program or operation and then edit or
delete the key.

STORING A PROGRAM

You can store the following numbers and functions in a program to enable easy transmission by simply executing
the program.
• Destination fax number • RESOLUTION and EXPOSURE settings • POLLING • SLOW SCAN MODE
• DUAL PAGE SCAN* • COVER SHEET • TX MESSAGE • OWN PASSCODE SELECT
• SENDING OPTIONS (CONFIDENTIAL TX, RELAY BROADCAST)
*The only settings that can be selected at the time of execution of a program that includes dual page scanning are
an original size setting and a timer transmission setting.
To store a program, follow steps 1 through 4 on pages 65 to 66 (touch the [PROGRAM] key in step 4), and then
perform the following procedure.
Timer transmission, original size, two-sided copying, and job build mode settings cannot be stored in a program.
Note
However, these settings can be selected when a program is used for transmission.
1
Touch the [PROGRAM NAME] key.
PROGRAM
No.1
PROGRAM NAME
ADDRESS
SETTINGS
RESOLUTION
SPECIAL
MODES
See page 80 for the procedure for entering letters.
2
Touch the [SETTINGS] key.
No.1
PROGRAM FOR SHARP
PROGRAM NAME
ADDRESS
SETTINGS
RESOLUTION
SPECIAL
MODES
The "No." that automatically
appears is the lowest
number from 1 to 8 that has
not yet been programmed.
When the PROGRAM
NAME key is touched, the
letter-entry screen appears.
Enter up to 36 characters
for the name.
3
Touch the keys for the settings that
you wish to store.
ENTER PROGRAM YOU REQUIRE.
AUTO
EXPOSURE
STANDARD
RESOLUTION
SPECIAL MODES
• The [10-KEY PAD] key can be touched to enter a
number with the numeric keys.
• For more information on selecting the settings, see
the following pages:
Exposure (p.22), Resolution (p.21),
Address Book (p.16),
Direct TX (p.7), Memory TX (p.7)
Special modes
• Polling (p.33) • Thin-page scanning (p.39)
• Dual page scanning (p.40) • Cover sheet (p.42)
• Transmission message (p.43)
• Sender (p.45)
• Confidential transmission (p.47)
• Relay request transmission (p.50)
4
Touch the [OK] key.
PROGRAMMING
CANCEL OK
ADDRESS
BOOK
10-KEY PAD
ADDRESS REVIEW
DIRECT TX MEMORY TX
73
6