G Transmission By Auto-Dialing; And Group Dialing) - Sharp AR-FX7 Operation Manual

BASIC OPERATIONS
TRANSMISSION BY AUTO-DIALING (RAPID DIALING

AND GROUP DIALING)

To send a document by auto-dialing (rapid dialing or group dialing), follow the steps below. To use an auto-dial
destination, you must first program the full fax number and name of the destination. Refer to page 11 for information
on auto-dialing and pages 67 and 71 for information on programming auto-dial destinations.
1
Perform steps 1 through 6 of "BASIC
PROCEDURE FOR SENDING FAXES"
(p.12).
2
Touch the [ADDRESS BOOK] key.
AKER REDIAL
Y:100%
ADDRESS
EPTION
BOOK
SUB ADDRESS
3
Touch the rapid key for the desired
destination.
READY TO SEND.
SHARP CORPORATION CORPO. TPS
SHARP GROUP
FREQUENT USE ABCD EFGHI JKLMN
4
Continue from step 7 of "BASIC
PROCEDURE FOR SENDING FAXES"
(p.13).
16
The address directory
screen appears.
This step is not
necessary if the address
directory screen already
appears (go directly to
step 3).
See page 8 for
information on using the
address directory screen.
The key you touched is
highlighted. If you touch
the wrong key, touch the
key again to cancel the
OPQ
selection.