Dx4010 Rs-232 Serial Interface Module; Dx4010 Installation; Figure 36: External Power For Sdi Devices; Figure 37: Dx4010 Rs-232 Serial Interface Module - Bosch D6412 Operation And Installation Manual

D6412/D4412
SDI Devices
12.3

DX4010 RS-232 Serial Interface Module

Bosch Security Systems' DX4010 RS-232 Serial Interface Module can be used to connect a standard serial printer, or other
serial devices, to the panel. It can also be used for a RAM IV remote programming direct connection. Refer to the DX4010
Installation Guide (P/N: 48210) for complete installation, addressing, and operating instructions.
12.3. 1

DX4010 Installation

The intended installation location for the DX4010 is in the plastic enclosure that it is shipped in. This is a low-profile,
aesthetically appealing housing that can be placed on a desktop or similar surface.
Distance from the panel is determined by the total combined wire length of all devices (including keypads) connected to the
panel's data terminals. The combined total wire length must not exceed 305 m (1000 ft.) for #22 AWG (0.8 mm), or 610 m
(2000 ft.) for #18 AWG (1.2 mm).
45349E
SDI Device
R B G Y
Red
+
External 12 VDC
Power Supply

Figure 36: External Power for SDI Devices

DB9 GND
Enable Pins (P1)
DB9 GND
ENABLE
P1
P5
P2
LED ENABLE
DB9 Connector
Diagnostic LED
Enable Pins (P2)

Figure 37: DX4010 RS-232 Serial Interface Module

D6412/D4412 Operation and Installation Guide
D6412/D4412
Green
Yellow
Black
-
R
Y
G
B
ON
1 2 3 4 5 6
1 2 4 8 16 M
SER RXTX RXTX BUS
Address DIP Switches
Diagnostic LEDs
Page 50
SDI Bus
© 2003 Bosch Security Systems