Table of Contents
Advertisement
Mounting
Install this board in the multi-format live switcher AV-HS400N/E.
<Notes>
Be sure to ask the store or dealer where you purchased the product for assistance
with mounting and removal.
Set to OFF and unplug the power connector before mounting and removal.
Before handling this board, touch a metal part of the AV-HS400N/E to discharge the
static electricity from the human body.
An anti-static wrist strap is recommended for safety. Failures may be caused if you
touch this board while you are still charged with static electricity.
Keep the metal parts of this board free of contact with other metal parts.
Be sure to mount the blank panel installed with the AV-HS400N/E, after removing this
board.
When installing or removing this board, take care not to hurt yourself on the edges
and metal parts of the boards.
Turn off the power of the AV-HS400N/E, and unplug the power cord.
Loosen the two screws of SLOT1 or SLOT2 on the output side at the rear of the AV-
HS400N/E, and remove the blank panel.
01.AV-HS04M4̲English.indd Sec1:8
01.AV-HS04M4̲English.indd Sec1:8
Blank panel
Screw
Screw
8 (E)
SLOT2
SLOT1
2007/10/01 18:33:09
2007/10/01 18:33:09
Advertisement
Table of Contents
