Wing Assembly - Hobbico Flitework Extra 300LP FLWA4003 Building And Instruction Manual

Then, attach the aluminium spacers to the firewall using
washers on both sides of the firewall and SHSC 4 x 20 mm
screws. Add a drop of threadlocker compound ont the screws.
Note that inner washers need to be cut to clear the triangular
spars.
The ESC will be secured as shown using Tie-Raps. The ESC
cables will be routed alog the fuse flanges to clear space for
the battery pack.
8

WING ASSEMBLY

Fit the ailerons to the wings like rudder and elevator, using thin
CA or PVA glue. Be carefully, because CA glue can make ugly
tracks on the surface of the wing. Feel out the slots for aileron
levers and open with sharp hobby knife. Glue the levers into
the aileron fins with 10 min. Epoxy. Put the aileron servos into
the servo frames and fix with wood screws. For 3D flight the
levers should have a length of 30 mm. We recommend the
Flitework carbon fibre servo lever set for Extra 300 LP (Order
no.:007-902)