Table of Contents
Advertisement
Quick Links
FLITEWORK T28-Mini / FLWA4130
Please read the instruction manual carefully and take notice of the safety guidelines.
If the model is given to a third party, always include this instruction manual to the model.
The Flitework Gmbh assumes no liability in case of misprints. Technical amendments reserved.
www.flyingbulls.at
Instruction manual
Distributed by
Fully licensed through the Red Bull GmbH - Austria
Wingspan
Length
Take off weight
Radio channels
Battery
- 1 -
650 mm
570 mm
330 g
A, E, M
3s 850 mAh
Advertisement
Table of Contents
Related Manuals for Hobbico FLITEWORK T28-Mini
Summary of Contents for Hobbico FLITEWORK T28-Mini
-
Page 1: Instruction Manual
Instruction manual FLITEWORK T28-Mini / FLWA4130 Wingspan 650 mm Length 570 mm Take off weight 330 g Radio channels A, E, M Battery 3s 850 mAh Please read the instruction manual carefully and take notice of the safety guidelines. If the model is given to a third party, always include this instruction manual to the model. - Page 2 Spare parts............6 Introduction............2 Scale spinner............6 General information..........2 Check list...............6 Environment protection infos.........2 Check list...............7 Safety precautions..........3 Hobbico service line..........7 Recommended accessories........3 Flitework contact............8 Additional items required........3 Kit check..............3 Content of delivery..........4 Installation of rudder and elevator......4 Assembling tail unit and fuselage......5 Elevator linkage.............5...
- Page 3 Before starting to build, use the Kit Contents list to take an inventory of this kit to make sure it is complete and inspect the parts to make sure they are of acceptable quality. If any parts are missing or are not of acceptable quality, or if you need assistance with assembly, contact Hobbico Product Support. Service center Revell GmbH Henschelstr.
- Page 4 1x Fuselage with main wing, mounted motor, prop, spinner, ESC and servos. 1x Fuselage upper part with canopy and pilot figures. 1x Rudder 1x Elevator with preinstalled flap lever. 1x Elevator linkage 1x Scale spinner 1x Multilingual instruction manual - 4 -...
- Page 5 Remove the color from the glueing areas by sanding the parts carefully. For hidden areas you can use a glass pencil, which you can get from the stationery store. If you put the parts together with 5 min. epoxy glue, take care for a correct alignment.
- Page 6 In the following picture you can see a possible placement FLWA4131 Motor cowl T28-Mini of the compnents like receiver and battery. To have no problem with the CG, you should place the receiver as FLWA4132 Fuselage upper part with canopy backmost as possible.
- Page 7 ● 10. Make sure there are silicone retainers on all the clevises and that all servo arms are secured to the servos with the screws in- cluded with your radio. Service department Revell GmbH Henschelstr. 20-30, 32257 Bünde, Germany Tel: +49 52239 65144 Email: service@hobbico.de - 7 -...
- Page 8 Remember to think. Have a ball! But always stay in control and fly in a safe manner. GOOD LUCK AND GREAT FLYING! Flitework GmbH Geymannstr. 27, 4713 Gallspach, Austria Tel: +43 664 3231 059 Email: office@flitework.at - 8 -...
Need help?
Do you have a question about the FLITEWORK T28-Mini and is the answer not in the manual?
Questions and answers