Table of Contents
Advertisement
AILERON- FLAP INSTALLATION
1.
Collect the following parts:
(1) Left wing
(1) Right wing
(1) Ailerons
(1) Flaps
(8) Pin hinges for flaps
(8) E-Z hinges for ailerons
2.
Start with one wing panel. Make sure all the
hinges are aligned and the aileron has a
1/16" gap at the wing tip.
3.
Insert a straight pin in the center of the hinge
so the hinges will be one half in the wing and
one half in the aileron.Push the ailerons in
place tight against the trailing edge of the wing
and remove the pins.
4.
Move the aileron to full deflection in one direc-
tion (about 1") and apply one drop of thin CA
glue to each hinge. Move the aileron to full
deflection in the other direction and apply one
drop of thin Ultra set CA on each hinge on that
side. Give the hinge a minute to dry then
apply one more drop to each hinge on each
side.
WING ASSEMBLY
5.
IMPORTANT: If the hinges are not inserted the
correct length the flap may not align with the
aileron and the wing root at the same time.
6.
1.
4
Insert the pin hinges in the flap and then fit
into the wing. Move the flap up and down.
The hinges will need to be adjusted so the flap
moves up and down smoothly and aligns with
the root rib
When satisfied with the alignment of the flap,
remove the flap, remove the hinges and put
epoxy glue in the hinge holes.
Reinstall the flap and make sure the alignment
is correct on both ends. Set aside till dry.
AILERON SERVO INSTALLATION
Collect the following parts:
(1) Left wing
(1) Right wing
(4) Servos
(2) 24" Servo Extension
(2) 6" Servo Extension
Advertisement
Table of Contents
