Table of Contents
Advertisement
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state. To use this function:
•
Jumper Setting
JP5, JP6, JP8 and JP13 must be set to "2-3 On: +5V_standby". Refer to "USB Power Select" in
this chapter for more information.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
Chapter 5 Ports and Connectors
Chapter 5
Graphics Interfaces
The display ports consist of the following:
•
1 DVI-I port
•
1 HDMI port
DVI-I
HDMI
HDMI Port
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
DVI-I Port
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only.
Connect the display device's cable connector to the DVI-I port. After plugging the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display devices in the Chipset menu ("System Agent Configuration" submenu) of
the BIOS. Refer to the chapter 7 for more information.
24
www.dfi .com
Advertisement
Table of Contents
