Table of Contents
Advertisement
PCH-FW Configuration
This section is used to configure the parameters of Management Engine Technology.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
ME FW Version
9.0.10.1372
ME Firmware Mode
Normal Mode
ME Firmware Type
Full Sku Firmware
ME Firmware SKU
1.5MB
Firmware Update Confi guration
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Firmware Update Configuration
Enables or disables Me FW Image Re-Flash function.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Me FW Image Re-Flash
[Disabled]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Chapter 7 BIOS Setup
Chapter 7
USB Configuration
This section is used to configure the parameters of the USB device.
Confi gure Management
Engine Technology
Parameters
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
Enable/Disable Me FW
Image Re-Flash function.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
39
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
USB Confi guration
USB Module Version
8.10.27
USB Devices:
1 keyboard, 2 Hubs
Legacy USB Support
[Enabled]
USB 3.0 Support
[Enabled]
XHCI Hand-off
[Enabled]
EHCI Hand-off
[Disabled]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Legacy USB Support
Enabled
Enables legacy USB.
Auto
Disables support for legacy when no USB devices are connected.
Disabled
Keeps USB devices available only for EFI applications.
USB 3.0 Support
Enables or disables USB 3.0 (XHCI) Controller support.
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI ownership
change should be claimed by XHCI driver.
EHCI Hand-off
This is a workaround for OSes that does not support EHCI hand-off. The EHCI owner-
ship change should be claimed by the EHCI driver.
Enables Legacy USB
support. AUTO option
disables legacy support if
no USB devices are
connected. DISABLE
option will keep USB
devices available only for
EFI applications.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
