Connecting An Acc Es Rugged 8-Port Appliance To A Power Supply - Motorola Avigilon ACC VMA-RPA-RGD-8P2 User Manual

Connecting an ACC ES Rugged 8-Port Appliance
to a Power Supply
The ACC ES Rugged 8-Port Appliance can be powered by any suitable 9–32 volt DC 100W (min) power
supply using the provided power cable.
The provided power cable has a connector at one end that plugs into the power connector on the rear of
the appliance, and three wires at the tail end labeled ACC (accessory), VCC, and GND.
To make a permanent power connection ( unswitched ), connect both the ACC and VCC wire to the positive
side of the power source. Connect the ground wire to the ground side of the power source.
To connect to a switched power signal (like a vehicle accessory signal in a vehicle), use the ACC wire. The
system will turn ON when the ACC wire is connected to the positive side of the power source. The system
will go into low-power standby mode when the ACC wire is disconnected from the positive side of the
power source.
Connecting an ACC ES Rugged 8-Port Appliance to a Power Supply 14