Motorola USB08 Reference Manual page 55

USB08 Evaluation Board
MOTOROLA
The module contains these three interface functions:
• initSSCI() — initialization of the software SCI module
• getSSCI() — receiving of a character
• putSSCI() — transmission of a character
The module initialization function initSSCI() sets the data direction
registers for the output and input port. Before this setting, a 1 is written
to the data register of the transmission line so that the output value of
this line is the standard high state.
The receive function getSSCI() waits until the state of the receiving line
changes to low. This indicates the beginning of the start bit of an arriving
byte. The following eight data bits are scanned suitably, in each case in
the center of the bit time. The result of this scanning is finally returned to
the calling function.
The available implementation does not examine whether the arriving
stop bit shows incorrect low levels (framing error). Also, an over
scanning for the purpose of noise reduction does not take place.
The production of the bit rate is controlled by the module-internal
function delayHalfBit(). The function is implemented with help from some
in-line assembly code to ensure an accurate time performance, which
can be simply changed by the user if necessary. The possible changes
necessary for the adjustment to different baud rates is documented in
the source text on the basis of two examples.
Adjustments regarding the port pins used as sending or receiving lines
are easily possible. The module uses five macros for the control and
scanning in of these pins. These macros are defined in the head of the
file U08232.C. Almost all port pins can be used for the software serial
communications interface (SCI) module by changing the bit masks
and/or the port designators in these macros.
In this demo application, the moderate baud rate of 2400 baud is
selected. An increase to 9600 baud is possible, but tests first must show
that the application runs without problems. It has to be taken into account
that the bit rate production is determined by a certain number of
execution cycles by the central processor unit (CPU), which temporarily
Software Module Descriptions
Software Module Descriptions
RS232 Communication Module U08232.C
Designer Reference Manual
55