Motorola USB08 Reference Manual page 240

Universal USB Device Driver (USBIO)
Table E-3. Registry Parameters Supported by the USBIO Driver (Continued)
Value
PowerStateOnClose
MinPowerStateUsed
MinPowerStateUnused
AbortPipesOnPowerDown
SuppressPnPRemoveDlg
DebugPort
DebugMask
DebugBaud
Designer Reference Manual
240
Min Default Max
0 3 3
0 3 3
0 3 3
0 0 1
0 1 1
0 0 3
0 3
2.400 57.600 115.200
Universal USB Device Driver (USBIO)
Description
Device power state that will be set when the device
is closed (last handle is closed).
0...3 correspond to D0...D3
The minimum power state of the device while it is
used (open handles exist). On system suspend
the device is not allowed to go into states higher
than this value.
0...3 correspond to D0...D3
The value 0 (D0) means: no suspend allowed if the
device is in use.
The value 3 (D3) means: full suspend (off) allowed
if the device is in use.
The minimum power state of the device while it is
not used (no open handles exist). On system
suspend the device is not allowed to go into
states higher than this value.
0...3 correspond to D0...D3
The value 0 (D0) means: no suspend allowed if the
device is not in use.
The value 3 (D3) means: full suspend (off) allowed
if the device is not in use
Handling of outstanding read or write requests
when the device goes into a suspend state
(leaves D0):
1 = abort pending requests
0 = do not abort pending requests
If this flag is set, Windows 2000 does not show a
warning dialog if the device is removed.
Destination of trace messages for debugging
purposes:
0 = kernel debugger or debug monitor
1...3 = COM1...COM3
This parameter is available only if the debug
(checked) build of the USBIO driver is used.
Control of message output for debugging. This
parameter is available only if the debug (checked)
build of the USBIO driver is used.
Baudrate selection for debug output to COM port.
This parameter is available only if the debug
(checked) build of the USBIO driver is used.
USB08 Evaluation Board
MOTOROLA