Assembly; Hardware Used - Power smart DB5023 Assembly Manual

1. Position the middle frame (B) with the arrow on the
"UP" decal pointing UP when viewed from rear.
Align the middle frame mount holes to the holes on
the lower frame (A).
Note: If middle frame (B) is installed upside-down,
the chute crank rod eye-bolt will not line up when
installing the chute crank rod.
2. Insert the handle saddle screw (AA) with the metal
washer (BB) into the aligned holes on each side. The
metal washer (BB) should be inserted outside of the
frame.
Note: Avoid damaging screw threads during installation.
M8x50 Handle Saddle Screw
8x 28x3
3.Use the handle camlocks (CC) to secure the connection.
The handle camlocks (CC) should be inserted outside of
the frame. Tighten the camlock just snug to the handle.
NOTICE: To avoid breaking the camlock, Do Not overtighten
the camlock. The camlock tightens as it is pivoted when
clamped. If the camlock is initially threaded too tight and then
clamped, it will break. Only slight clamping pressure is
required to hold the handle in place.
Handle Camlock
UP
Decal viewed from rear.