Assembly - Power smart DB2801 Instruction Manual

ASSEMBLY

The following section describes steps necessary to prepare the snow thrower for use. If after reading
this section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri
9-5 EST for customer service assistance. Failure to perform these steps properly can damage the snow
thrower.
Unpacking
Unpack the snow thrower and all its parts and compare against the list below.
1. Snow Thrower
2. Discharge Chute Assembly
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before using
your Snow Thrower.
Step 1: Installing the Upper Handle
Turn up upper handle.
1.
Tighten the quick knob as Fig.1.
2.
Step 2: Installing The Chute Assembly
1. Insert chute to the base. (See Fig. 2).
2. Secure chute to base with (3) Screws, washers and nuts provided.
Fig.1
Fig.2
12