Cub Cadet RT 75 Shop Manual page 36

RT 75
40. Slide the shifter fork out of the dog clutch collar.
41. Remove the snap ring that retains the spring and
washer, using a pair of snap ring pliers.
42. Slide the washer, spring, and the dog clutch collar
off of the wheel shaft.
43. Remove the two snap rings that secure the worm
gear to the wheel shaft.
44. Remove the front drive shaft oil seal, using a flat
blade screwdriver.
45. Remove the front internal snap ring, using snap ring
pliers.
46. Remove the front tapered roller bearing race by
lightly tapping on the perimeter, using a blunt ended
punch and a hammer or a bearing driver.
47. The race should be gently pushed into the center of
the transmission housing for ease of removal.
48. Clean and inspect all of the parts for signs of wear
or damage.
32
Worm gear
Snap ring
Shifter fork Clutch collar
Figure 6.14
Front drive shaft oil seal
Figure 6.15
Snap ring
Snap ring
Spring Washer