Cub Cadet RT 75 Shop Manual page 32

RT 75
7. Remove the retaining ring that secures the right
wheel shaft bearing, using a pair of snap ring pliers.
8. Remove the eight screws that secure the side cover
to the transmission housing, using a 3/8" wrench.
See Figure 6.3.
NOTE: It is not necessary to remove the snap ring
and the left wheel shaft bearing. They will
come off with the side cover.
9. Gently pry the side cover off of the transmission.
See Figure 6.4.
NOTE: There are two alignment pins that go
through the side cover into the transmission
housing.
10. Push the wheel shaft to the right, forcing the right
wheel shaft bearing out of the transmission housing.
NOTE: The bearing is a slip fit. It may take several
tries of pushing the wheel shaft to the right,
while wiggling it, to walk the bearing out of
the transmission housing.
11. Remove the bearing and washer from the right side
of the wheel shaft.
12. Remove the snap ring from the side cover.
13. Remove the wheel shaft bearing from the side
cover. See Figure 6.5.
14. Remove the shift fork oil seal from the side cover.
28
Side cover
Figure 6.3
Figure 6.4
Wheel shaft bearing
Figure 6.5
Alignment pins
Shift fork oil seal
Snap ring