Cub Cadet RT 75 Shop Manual page 17

Disconnect
this cable
Figure 3.6
Disconnect cable
Figure 3.7
Loosen this screw
6. Loosen, but do not remove, the screw securing the
cable pulley. See Figure 3.6.
7. Slip the cable off of the pulley.
8. Disconnect the black cable fitting from the cable
bracket. See Figure 3.6.
9. Unhook the spring end of the cable from the forward
idler bracket. See Figure 3.7.
NOTE: The spring end of the cable is to help prevent over
tensioning of the drive belt.
10. Install the cable by following the previous steps in
reverse order.
11. Test run the tiller in a safe area before returning it to
service.
Cables
13