ElliptiGO 8S Owner's Manual page 61

Adjusting the Foot Platform Position
on the Arc Model
On the Arc model, the foot platform can be adjusted relative
to the pivot axis to improve the functioning of the pivot while
pedaling. Each foot platform is secured to the pivot by four
screws and is labeled with position indicators. Typically, the
larger the rider's foot, the further forward the platform will need
to be for optimal pivoting and the smaller the rider's foot, the
further back the platform will need to be for optimal pivoting.
The foot platform positions are numbered from 1-6 with 1 being
the furthest back position and 6 being the furthest forward
position. Once you have set the new foot platform location,
check the Foot Platform Positioning Chart on the next page to
ensure that your bike is safe to ride.
To adjust the foot platform position, follow these steps:
1. Using a 4mm Allen wrench, loosen the foot platform
screws until they clear the teeth in the foot platform screw
channels.
2. Slide the foot platform to the desired position and ensure
that the screws and washers are aligned between the foot
platform channel teeth.
3. Tighten the screws to 4-6 Nm.
WARNING! After making any adjustment to the foot
platform or pivot axle location, always ensure that the
new settings fall in an "OK" position on the Foot Platform
Positioning Chart above. If the new combination falls in a red
area, then DO NOT RIDE. Reset your positions such to place
them in an OK area on the chart. Riding with positions falling
in a red area will likely result in the foot platform striking the
swing arm or frame during riding, which could cause the rider
to lose control and suffer a fall.
2
3
1
Owner's Manual
III
III