ElliptiGO 8S Owner's Manual page 45

Rear Wheel Installation – Arc Model
To install the rear wheel on the Arc model, follow these
steps:
1. Place the bike on the kickstand.
2. Ensure the gear selection lever is in 8th gear.
3. While pulling the derailleur rearward to create space,
guide the ends of the quick release skewer into
the corresponding dropouts on the frame.
4. Seat the wheel fully in the dropouts and ensure that it
is centered in the frame.
5. Close the quick release lever. Follow the detailed
instructions set forth in the Quick Release Clamping
Systems section above.
WARNING! Securing the rear wheel quick release
properly is critically important. An improperly adjusted
quick release can allow the rear wheel to become loose
or detach from the bike. If the rear wheel detaches from
the bike while you are riding it, you will lose control and
suffer a serious injury or be killed. Make sure to follow
the instructions set out in the Quick Release Clamping
Systems section when closing a quick release lever. Make
sure to check the security of your quick release levers
before each ride.
6. Reattach the rear brakes. Follow the detailed
instructions in the Brakes section above.
WARNING! Ensure that the brake quick release system
is properly closed and your brakes are functioning
properly before riding your bike. If the brake quick
release system is open or closed improperly, the brake
2
3b
5
3a
4
6
Owner's Manual
II