ElliptiGO 8S Owner's Manual page 56

3. Looking at the bike from the left side, insert a 2.5mm
Allen wrench into the drive arm axle retention screw
on the right crank arm. Rotate the Allen
wrench clockwise until the screw is completely
removed.
4. Insert a 6mm Allen wrench into the back of the right
drive arm axle. While holding the drive arm still,
rotate the Allen wrench clockwise until the drive arm
axle is completely unscrewed.
5. Remove the washer from the crank arm counter-bore
and insert it into the counter-bore of the new position.
3
4
5
Owner's Manual