ElliptiGO 8S Owner's Manual page 26

Each brake has a quick release mechanism that enables the
corresponding wheel to be removed without deflating the
tire. To open the brake quick release system, follow these
steps:
1. Place the bike on the kickstand.
2. With one hand, squeeze the calipers together.
3. While holding the calipers, use the other hand to
pull the brake noodle towards the hinge of the
bracket (towards the left caliper). Use a finger of the
hand squeezing the calipers to push the bracket
cage down while simultaneously pulling up on the
brake noodle so that the brake cable passes through
the slot in the top of the quick release bracket.
4. Release the calipers so that they can spring open.
To close the brake quick release system, follow these
steps:
1. Place the bike on the kickstand.
2. With one hand, squeeze the calipers together.
3. With the other hand, pull the brake noodle towards the
hinge of the bracket and slide the cable through the
slot in the bracket. Then release the brake noodle so
that it slides through the large hole at the edge of the
bracket.
4. Release the calipers and test the brakes by actuating
the corresponding brake lever on the handlebars and
ensuring the close properly.
WARNING! Ensure that the brake quick release system is
properly closed and your brakes are functioning properly
before riding your bike. If the brake quick release system
is open or closed improperly, the brake will not function.
Riding without operating brakes is extremely dangerous
2
4
3
3
2
4