Download  Print this page

Advertisement

1.5 Names and Functions of Components

1.5.1 Front

[1] Top cover
Open this cover when installing the printhead or remove the media jammed inside the printer.
[2] Ink tank cover
Open this cover when replacing ink tanks.
[3] Cutter
A round-blade cutter cuts roll media automatically. It is stowed inside when it is out of use.
[4] Front manual feed guides
Erect all these guides to print on thick paper. Place thick paper along the guides and insert it up to the alignment lines while pressing the paper to the
right side.
[5] Paper eject slot (paper tray front loading port)
All printed matter is ejected from this port. In loading thick paper, insert it into this port.
[6] Paper alignment line
Load thick paper in a paper tray to stay parallel with this line.
[7] Basket
Receives printed matter as it is ejected. Only one sheet can be housed in the basket.
[8] Stand
The base on which the printer is mounted. The stand equipped with casters is easy to move.
[9] Output guide
Holds ejected paper from lifting.
[10] Operation panel
Contains the power button, online button display and so on.
[11] Roll feed unit
Load roll media on this unit.
[12] Roll feed unit cover
Load roll media with this cover open.
[13] Paper tray cover
Load cut sheet at the paper tray top loading port with this cover open. This cover is opened, and the cut sheet is set at top manual feed slot.
[1]
[2]
[3]
[4]
[5]
[13]
[12]
[7]
[6]
F-1-17
[11]
[10]
[9]
[8]
Chapter 1
0016-8143
1-13

Advertisement

Table of Contents

Troubleshooting

Comments to this Manuals

Symbols: 0
Latest comments: