Canon iPF605 Service Manual page 213

J1001 (IEEE1394 board)
Pin Number Signal name
74 AD2
75 AD1
76 AD0
77 GND
78 HDD_LED
79 +5V
80 +5V
81 +5V
82 +3.3V
83 +3.3V
84 +3.3V
85 GND
86 GND
87 GND
88 GND
J1201 (network)
Pin Number Signal name
1 TX+
2 TX-
3 RX+
4 -
5 -
6 RX-
7 -
8 -
9 GREEN_LED_C
10 GREEN_LED_A
11 YELLOW_LED_C
12 YELLOW_LED_A
J1801 (to power supply PCB)
Pin Number Signal name
1 HD1_VHFB+
2 HD1_VHFB-
3 VH
4 GND
5 VH
6 GND
7 RGV20(VCC)
8 GND
9 VM
10 GND
11 VM2
12 GND
13 VH_ENB
14 PW_CONT
J2511 (spur motor, spur cam sensor, mist fan, cutter motor, cutter right position sensor)
Pin Number Signal name
1 +3V
2 GND
3 CUTTER_R_SNS_R
4 CUTTER_OUTA
5 CUTTER_OUTB
6 +3V
7 GND
8 HAKUSHA_CAM_SNS_R
9 HAKUSHA_MOTOR_AM
10 HAKUSHA_MOTOR_AP
11 FAN_VM
IN/OUT Function
IN/OUT Address and data signal 02
IN/OUT Address and data signal 01
IN/OUT Address and data signal 00
- GND
- N.C.
OUT Power supply (+5V)
OUT Power supply (+5V)
OUT Power supply (+5V)
OUT Power supply (+3.3V)
OUT Power supply (+3.3V)
OUT Power supply (+3.3V)
- GND
- GND
- GND
- GND
T-6-3
IN/OUT Function
OUT Ethernet data TX line (+)
OUT Ethernet data TX line (-)
IN Ethernet data RX line (+)
- Not used
- Not used
IN Ethernet data RX line (-)
- Not used
- Not used
OUT Link LED (green:100Mb/s) cathode terminal
OUT Link LED (green:100Mb/s) anode terminal
OUT Link LED (yellow:10Mb/s) cathode terminal
OUT Link LED (yellow:10Mb/s) anode terminal
T-6-4
IN/OUT Function
OUT VH feedback voltage +
OUT VH feedback voltage -
IN Power supply (+21.5V)
- GND
IN Power supply (+21.5V)
- GND
IN Power supply (+21.5V)
- GND
IN Power supply (+26V)
- GND
IN Power supply (+26V)
- GND
OUT VH power supply ON/OFF signal
OUT Normal/power saving switch signal
T-6-5
IN/OUT Function
OUT Power supply (+3.3V)
- GND
IN Cutter right detection sensor signal
OUT Cutter motor driver signal A
OUT Cutter motor driver signal B
OUT Power supply (+3.3V)
- GND
IN Spur cam sensor output signal
OUT Spur motor drive signal AM
OUT Spur motor drive signal AP
OUT Power supply (+26V)
Chapter 6
6-3