Troubleshooting - Eaton Powerware 5110 User Manual

Troubleshooting

Symptom
Powerware 5110 UPS will
not turn on.
Powerware 5110 UPS is
making a continuous sound
and the "Overload" indicator
is light.
Powerware 5110 UPS
does not provide expected
runtime.
Connected equipment's lose
power while connected to
the Powerware 5110 UPS
12
Possible Cause
UPS is not turned on or
battery is not connected.
Circuit Breaker has tripped.
The "Battery Backup &
Surge Protection" outlets are
overload.
Due to age the battery does
not hold a full charge.
The "Battery Backup &
Surge Protection" outlets are
overloaded.
The Powerware 5110 UPS
has depleted the battery.
Connected equipment is
connected to the wrong
outlet.
The Powerware 5110 UPS
may be faulty.
User's manual
350 - 1500 VA
Action to Take
Switch on the ON/OFF switch. If the
power is not present, please make
sure your circuit breaker on the
building is not accidentally turned
off.
Reduce the amount of equipment
plugged into the "Battery Backup
& Surge Protection" outlets of the
UPS. Next, reset the circuit breaker
by pushing it back in.
Reduce the amount of equipment
connected to these outlets.
Charge the battery for at least 8
hours and recheck the battery
runtime
Battery might need to be changed,
look on battery replacement.
Refer to the Indicator Table
"Powerware 5110 UPS is making a
continuous sound and the Overload
indicator is lit."
The Powerware 5110 UPS will turn
off when the battery has been
depleted during the failure of utility
power. Allow UPS to re-charge
before continuing use of the UPS.
Ensure that the equipment you
want to stay powered during a
failure of utility power is plugged
into the "Battery Backup & Surge
Protection" outlets.
Please Call your local Powerware
representative for further
troubleshooting.
1023922
Revision A