Battery Connection Required Before Use; Connecting The Battery; Installation And Operation - Eaton Powerware 5110 User Manual

Hide thumbs Also See for Powerware 5110:
Table of Contents

Advertisement

Battery connection required before use!

Connecting the Battery:

Principal shown below for detailed information how to connect please refer to battery
replacement section.

Installation and Operation:

Following steps explain how to connect and operate the Powerware 5110 UPS.
1. Connect the UPS to a grounded power outlet.
2. Plug your computer, monitor or load to be protected into the "Battery Backup &
Surge Protection" outlets. (These outlets will provide emergency battery backup
power during power outages as well as protection from surges and spikes.)
Do NOT plug LASER PRINTERS into the "Battery Backup" outlets.
Do NOT plug ACCESSORY SURGE strips into the "Battery Backup" outlets.
3. Plug your peripheral equipment or non-critical loads (printer, scanner, fax, speaker,
etc.) into the "Surge Protection" outlets. (These outlets provide surge and spike
protection only, they will NOT provide battery backup power during a utility power
failure).
4. With your equipment turned off, switch on the UPS.
5. When the "On/Off" LED light is illuminated, turn on the connected equipment.
6. Connect your computer to the UPS using USB cable provided.
Install Power management software provided with the UPS
6
User's manual
350 - 1500 VA
1023922
Revision A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents