Replacing/Repairing; Drive Belts - Walker T27i Operator's Manual

Maintenance Instructions

REPLACING/REPAIRING

To prevent accidental starting of the en-
gine when replacing parts or repairing the
machine, remove the key from the ignition
switch and disconnect the spark plug
wires.
IMPORTANT: ALWAYS use genuine factory re-
placement parts. Substitute parts CAN result in
product malfunction and possible injury to the op-
erator and/or others.
72
DANGER
Hydrostatic Ground
Drive Belt

Drive Belts

There are four (4) individual belts on GHS models
or three (3) belts on SD models:
•
Jackshaft Drive Belt
•
Engine PTO Drive Belt (3 Groove Power Band)
•
GHS Blower Drive Belt (GHS Model Only)
•
Hydrostatic Ground Drive Belt
The belts may be removed and replaced using the
procedures described on the following pages.
Jackshaft
Drive Belt
Belt Locations
REPLACING/REPAIRING
Engine PTO
Belt
GHS Blower Belt
(GHS Model Only)