Table of Contents
Advertisement
If this command is terminated with a CHECK CONDITION
status, the sense code/sub-sense code in the sense data is other
than "No defect spare location available [=32-00], and a valid
logical block address (other than X 'FFFFFFFF') is displayed in
the "Command inherent information" field, it is necessary for the
INIT to reissue this command by the following procedure after
executing recovery processing (shown in Section 4.2) in
accordance with the contents of the sense data.
1)
Defect Descriptor List
Delete
2)
4 - 106
IMPORTANT
Delete the defect descriptors which precede the defect
descriptor that specifies the logical block address displayed
in the "Command inherent information" field of the sense
data from the defect descriptor list specified in this
command, and leave that defect descriptor in the list.
XXXX
Logical block address that indicates the "Command inherent
information" field of the sense data.
Change the "Defect List Length" in the header and add the
new "Defect descriptor list" corrected in 1), then reissue the
REASSIGN BLOCKS command.
C141-E054-02EN
Advertisement
Table of Contents
