Table of Contents
Advertisement
When "1" is specified in this bit, the IDD prohibits tagged queuing processing. The IDD
clears queued commands and generates a UNIT ATTENTION condition (Command
cleared by another initiator [=2F-00]) for each of the INITs that issued the commands
which were cleared. After that, the when a QUEUE TAG message is received, it is
rejected with a MESSAGE REJECT message and executed as an untagged command.
The IDD cannot specify "1" in this bit.
e. RAC (report a check) (not supported)
This bit specifies control of the Long-Busy condition (Busy condition in the ACA state) or
Check Condition report.
"1" : Prohibits reporting of the Long Busy condition. Instead, the Check Condition is
reported.
"0" : Permits reporting of the Long Busy condition.
This IDD does not support this bit.
f. SWP (software write protect) (not supported)
This bit controls permission or prohibition to write to the medium.
"1" : Prohibits writing to the medium and returns the Check Condition status for all
command in which writing is necessary.
"0" : Permits writing to the medium.
This IDD does not support this bit.
g. RAEN, UAEN, EAEN (not supported)
This IDD disregards the values specified in the above parameters.
h. Ready AER Hold Off Period (not supported)
This shows the minimum time (msec) until the target can issue an Asynchronous event
report after starting an initialization sequence accompanied by a delay period.
This IDD disregards the value specified in this parameter.
i. Busy Time-out Period (not supported)
This shows the maximum time (100 ms) that the IDD is permitted to hold the BUSY state
with respect to the target.
This IDD disregards the value specified in this parameter.
4 - 50
C141-E054-02EN
Advertisement
Table of Contents
