Table of Contents
Advertisement
5. Correct installation of ball link and brass spacer
to servo arm shown below.
Improperly installed servo linkages can cause ser-
vos to strip and elevators to flutter. Elevator flutter
can and will destroy your model instantly!
6. Adjust the length of the elevator pushrod so that
the servo arm is 90 degrees to the servo case
when it is placed on the servo output shaft. En-
sure the servo does not bind at either end point at
full deflection.
7. Repeat the above steps for the other stab and
elevator.
Rudder Servo and Pull-Pull Cable
1. Mark and use a 1/16 bit to drill the rudder servo
mounting holes.
2. Install rudder servo with output shaft towards
the front.
24
Installation
Hide quick links:
Advertisement
Table of Contents
