Rudder Pull-Pull Cable Installation - AeroWorks .90-1.20 YAK 54 ARF-QB Assembly Manual

2. Install the rudder servo into the rudder servo
mounting tray with the servo output shaft
toward the tail.
3. Mark and use a 1/16 bit to drill the rudder
servo mounting holes.
4. Install rudder servo with servo screws.

Rudder Pull-Pull Cable Installation

1. Gather the rudder control linkage parts shown
below. (2) Rudder cables, (4) brass swaging
tubes, (2) control horns, one left one right (4)
mounting screws each, and (4) RC links with
threaded couplers.
22