SurgeX SX-1115ip-X User Manual page 8

Web-enabled power conditioning management system
Table of Contents

Advertisement

iControl Manual
Setting the IP address using CLI
These are the basic commands to set the network parameters. After setting these parameters, the
iControl will need to be rebooted for the settings to take effect. Any command that requires
rebooting of the iControl will provide a prompt to do so. All commands may be entered as
required before rebooting.
Example: Telnet to default IP address 192.168.0.254 on Port 23.
iControl Rev Q101124G.272
User Name: admin
Password: *****
iControl > set ipaddress 192.168.1.3
Reboot Required!
OK
iControl > set subnet 255.255.255.0
Reboot Required!
OK
iControl > set gateway 192.168.1.7
Reboot Required!
OK
iControl > reboot
IP Address = 192.168.1.3
Once the IP address is set, the following command can be used to prevent DHCP or ARP-Ping
from altering it: set ipmode static
Setting the IP address from a DHCP Server
A DHCP server will automatically assign an IP address (dynamic address) as well as Subnet
Mask and Gateway to the iControl.
To enable this feature, configure the iControl with the command set ipmode dhcp
Then reboot the iControl, or enter the command reboot
To find the IP address of the iControl, you will need to query your DHCP server and locate the
MAC address of the iControl in the DHCP server's IP / MAC table. You can also access the CLI
and use the get network command, or use the Discover provision of the iControl Setup and
Control Utility (SCU).
7

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SX-1115ip-X and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Sx-1120ip-x

Table of Contents