Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SurgeX Multipak SX-DS-154
Summary of Contents for SurgeX Multipak SX-DS-154
- Page 1 User Manual SX-DS-154 / SX-DS-156 User Manual 120V Firmware Revision 1.67 and higher Software Revision 4.0 and higher 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com / UM-MultiPak-Rev-B...
- Page 2 User Manual © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com...
-
Page 3: Table Of Contents
................... 12 HART ................13 UTLET ONTROL ................14 ISTORICAL ..................16 ETTINGS ................17 ETUP ................17 OMMAND PERATION VI. TROUBLESHOOTING MULTIPAK ..................... 18 Software......................18 VII. SPECIFICATIONS © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 4: Models
(detailed in Section V: Using the Software) 3. Technical Support: • To download software and access further product information, visit http://espsurgex.com/product/multipak/ • For technical support, please contact SurgeX at 1-800-645-9721 © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 5: Installation Instructions
MULTIPAK into a known properly functioning outlet. If the “System On” LED still does not illuminate in the functioning outlet call SurgeX at 1-800-645-9721. If the “System On” LED illuminates, contact a licensed electrician to troubleshoot the abnormal voltage condition. -
Page 6: Hardware
Diagnostic Software: The device microcontroller memory may be cleared from within the Diagnostic Software in the following location: “Tools/Clear Device Memory”. See Section V for details. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 7: Software Installation
3. Download and Install Software a. Download the Software Installer from www.espsurgex.com b. Unzip and run the installation utility. c. Follow the on-screen instructions to complete installation of the software. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 8: Install Data Interface Cable
2. Start the Software a. Double-click the desktop shortcut labeled “ESP SurgeX Diagnostic Tool”, or use the “ESP SurgeX Diagnostic Tool” Start Menu shortcut located at: Start/All Programs/ESP SurgeX/Diagnostic Tool © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 9: Configure The Data Interface Cable And Com Port
“Run As Administrator”. It may also be necessary to run the compatibility wizard by right-clicking the shortcut, selecting “Troubleshoot Compatibility”, and following the prompts. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... - Page 10 5. In “USB Transfer Sizes”, change both the “Receive” and “Transmit” values to 4096. 6. In “BM Options”, change the “Latency Timer” value to 2. 7. Leave all other settings at default. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com...
-
Page 11: Software Modes
Analysis tool. Press the Expert button to perform an expert analysis of recorded time-stamped event data or chart measurements and generate a PDF report of potential conclusions and recommendations. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 12: Multimeter Mode
Multimeter Mode The Multimeter Mode provides information traditionally acquired from a handheld digital multimeter, as well as an overview of the recorded power quality events. ±2% Typical Measurement Accuracy. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 13: Chart Mode
Line Voltage: AC RMS Volts. Peak Measurement Type • • Neutral-Ground Voltage: AC RMS Volts Neutral-Ground. Peak Measurement Type. Available with 120V models with firmware version 2.00 and later. ±1V accuracy from 3V-10V. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 14: Outlet Control Mode
When commanded, the outlets will turn off, and then back on, after a 90 second delay. The Power Cycle indicator will be illuminated while a power cycle is active. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 15: Historical Data Mode
Next Gen is able to store and timestamp the 60 most recent power quality events in its internal memory. Press the Import Time Stamped Data button to download the event data.yuikl © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... - Page 16 Press the button that corresponds to the type of data file to import and browse to the location of the file. Note: “Import Historical Data from file” applies to enVision PCS, not Next Gen PCS. 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com / UM-MultiPak-Rev-B...
-
Page 17: Settings Mode
Under Voltage < V < UV Outlets stay On and Shutdown Record event recorded Record V < UV Under Voltage Outlets turned Off and Shutdown Shutdown event recorded (Disabled) © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 18: Com Port Setup Mode
Write Timestamped data. Write Event Counts. Write Measurements. If neither -t, -c, nor -m is specified, all will be written. If -a is not specified, output file will be overwritten. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 19: Troubleshooting
Interface Cable and COM Port section of this manual. Wrong or corrupt file. A file import operation has Select a valid data file for import. been attempted with an invalid or corrupt data file. © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com... -
Page 20: Specifications
User Manual VII. Specifications © 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com...
Need help?
Do you have a question about the Multipak SX-DS-154 and is the answer not in the manual?
Questions and answers