Group Commands - SurgeX SX-1115ip-X User Manual

iControl Manual
set unit <hwkey> device <2‐16>
set factory defaults
logout
reboot

Group Commands

Command
get groups
get group <groupname>
set group <groupname> <on/off/cycle>
add group <groupname>
set group <groupname> device <#1‐#16/devname/all>
outlet <1‐8/all> <yes/no>
ren group <groupname> <newname>
del group <groupname>
Sets the ID of a remote device in cluster configurations. The hardware
key <hwkey> is the last 2 bytes of the MAC address with NO spaces,
dashes or colons.
Resets all parameters to their factory settings including the IP Address.
Only available on the serial port. Confirmation is required.
Note: This command can take up to 30 seconds to execute.
Ends the session.
Reboots the selected iControl. This will not change the status of the
outlets of standalone or Master of cluster configuration (device ID 0 or
1). May cause outlet changes in expansion units (device ID 2-16).
Description
Returns a list of the groups that the current user has rights
to.
Returns the details of the selected group.
Controls the selected group.
Adds a new group. 20 characters max. Up to 8 groups
maximum.
Adds or deletes a specific outlet on a specific device from
the selected group.
Renames the selected group. 20 characters max.
Deletes the selected group.
18
Yes
In this example, the
<hwkey> is 38A2.
Yes
No
Yes
Admin
No
No
No
Yes
Yes
Yes
Yes
Fact Def