Table of Contents
Advertisement
3D camera board
NOTE:
The 3D camera board spare part kit does not include the 3D camera board cable. The 3D camera
board cable is available using spare part number 830336-001.
Description
3D camera board (includes double-sided adhesive)
3D camera board with foil (includes double-sided adhesive)
Before removing the 3D camera board, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the display panel assembly (see
the following components:
a.
Right microphone (see
b.
Front-facing webcam (see
c.
Rear-facing webcam (see
Remove the 3D camera board:
1.
Disconnect the 3D camera board cable (1) from the system board.
2.
Detach the 3D camera board foil (2) from the back cover. (The 3D camera board foil is attached to
the back cover with double-sided adhesive.)
34
Chapter 5 Removal and replacement procedures
Display panel assembly on page
Microphone on page
31)
Front-facing webcam on page
Rear-facing webcam on page
Spare part number
830351-001
836232-001
20), and then remove
32)
33)
Hide quick links:
Advertisement
Table of Contents
